EDAs Conference Paper submission format problem and EPS picture display not whole problem

Due to a boundary problem when submitting the detection, the A4 condition is not met

\documentclass[conference]{ieeetran the template}

Switch

\documentclass[conference,letterpaper]{ieeetran}

\geometry{left=0.68in,right=0.68in,top=0.85in,bottom=1.1in}

In addition, when compiling, you can choose Latex+dvi2pdf, and there will be no font embedding problems.

However, it is possible that the EPS picture display is not complete problem, this is because the EPS picture is too large, open with Gsviewer will find that the picture can not be fully displayed.

At this point, you can use Adobe Illlustrator to open the EPS and then shrink it to a single page of paper, then save it in EPS format again. Latex can be displayed normally.