Error 1075: The dependency service does not exist or has been marked as deleted. (The error is displayed when ArcGIS Server cannot be started)

Symptom: When logging on to Ufida, the system prompts that the service has not been started. When you start the service in the management attack, the system reports an error: 1075, the dependent service does not exist, or the service has been marked as deleted.

Solution: 1. Double-click the service you want to enable. In the displayed panel, select the dependency tab to view the services that the service depends on. Enable all dependent services, and then manually restart the services.

2. If "error 1075: dependency service does not exist or is marked as deleted" is still encountered after step 1, it indicates that the dependency service is not started. Because the dependent services listed in step 1 are only recognized by the system and are the most basic. To view the complete list of services that a service (assuming its name is XXX) depends on, perform the following operations:
Start-> run, and press Regedit (regedit32 is recommended, if this command is available). Press enter to find HKEY_LOCAL_MACHINE/system/CurrentControlSet/XXX, double-click the dependonservice item of XXX to view the list of dependent services.

3. There are two solutions:
3.1) Launch all the dependent services like step 1 (not recommended)
3.2) delete the list of redundant dependent services in dependonservice and retain only the most basic dependent services. Note that the end of the service list should be a space or a blank line.
You can also run SC config XXX depend = YYY in "start-> Run" to set the dependency service YYY of service XXX. Similarly, "depend =" must be followed by a space.

AboveArticleI found it on the Internet. After a long time, I learned what XXX means. For example: