Error: Dynamic drive overlay not loaded displayed during system reinstallation

 

Whether using genuine XP or ghost XP
Restart and you will find
The content in the blue background box above is not displayed on the computer.
There are more
Errorynamic drive overlay not loaded.
Insert boot diskette in drive a; Press spacebar when ready ......

Some of my peers who have encountered the same problem on the internet can solve the problem as follows:
{Meaning: Error: Dynamic drive overwrite not loaded.
Insert the boot floppy disk to drive a:. After the disk is ready, press the Space key.
This is because when you use DM to partition
DM automatically loads the DDO driver
The C disk is not set as an active partition during installation.
At this time, you only need to delete the DDO driver loaded to Zone C.
After the above situation occurs, it is useless in the low level.
Solution:
Run the DM partitioning tool on your CD
Run DM ----- clear the ontrack driver loaded by DM !!! The details are as follows:

(A) dvanced options --> (m) aintenance options --> (d) ynamic drive overlay --> (r) emove dynamic drive overlay

When the disk is started, the blue DDO boot information is no longer displayed.

Or simply select easy... to repartition.
In this case, you can directly use the original installation disk to install it}
However, the above solution does not work if I use it. There is no problem with the hard disk and hard disk data cable. The memory is also changed. I heard that this is caused by DM. I also did not use the PM. Is there any better way to solve this problem?


Motherboard is: ZMBLP31E-L
Q: When I used the DM partition, I found that there was another storage medium besides my hard disk.

After repeated twists and turns, the computer has finally become full of vigor. The fault analysis is as follows:
{Suspect: I found that there is another storage medium besides my hard disk when using DM partition}
The above sentence. Personal analysis should be a small partition automatically provided by DM partition, where DDO is installed. This small partition is made into a pilot partition. Although it is the system, no matter how you view it, it is done on the hard disk. However, when the computer is guided, he cannot find the system location, causing the computer to fail to start properly.
My reasoning process: When this small partition is used in the DM format and then restarted. The computer just said that the system could not be found, but did not provide DDO guidance. Therefore, the reasoning of this small partition is where dm places DDO.
Solution: Run diskgen. Re-partition and activate drive C as the boot disk. Note that the diskgen support can be allocated to 10 Gb more. Therefore, only one 10 Gb installation system can be split. After completing the configuration. Reboot the system and enter the system smoothly.
The problem has been solved so far. Thank you for your attention!