After preparing for Wireless Bridge installation, see "instance Description: Installing Wireless Bridge 1. The installation and configuration of wireless bridges are not very complex, but many friends have little contact with each other and are unfamiliar with the operation. In the following sections, we will record every step and hope to help you.
DCOM-NWH6110 Wireless Bridge installation Configuration
Three steps:
Step 1: first plan the entire network structure.
Step 2: connect the DCOM-NWH6110 in the room, turn on the power switch, then install the configuration tool in the computer in the network and configure the wireless bridge device, so that it can work properly.
Step 3: Install the Wireless Bridge in the network and align it with the outdoor antenna.
1. install and configure the Wireless Bridge
Step 1: insert the tool disk to the computer, run setup.exe, and the installation page is displayed. 1) Click NEXT to perform the NEXT step.
Step 2: Enter the installation path 2) and click NEXT to perform the NEXT step.
Step 3: Enter the added program item 3) and click NEXT for the NEXT step.
Step 4: Click Finish. 4)
2. configuration tools used in Wireless Bridge installation and configuration
Step 1: Click Start/Program/Management System. The bridge Management interface is displayed.
Step 2: Start/Start Hosts View.
If the IP address of the bridge is set or forgotten for the first time. Press and hold the reset switch for one second to reset the bridge. The default IP address of the bridge is to automatically obtain the IP address. If you use a single-host configuration, you can use a cross-network cable to connect the bridge and PC, set the PC to automatically get the address mode or set the IP address to 169.254.X.X, mask to 255.255.0.0 ). Run the configuration tool software and click Auto Discovery (F5) to find the bridge. Then configure. If you connect to a LAN with DHCP service, press Auto Discovery (F5) to find the bridge. Then configure.
Step 3: select the bridge to be configured and configure the bridge according to the Config Device icon. For example: