This chapter will teach you how to use brushes and simple lines to make a sense of design in 5 minutes.
The final diagram of the examples in this chapter:
Start ~!
01
First, pull out four squares with a width and height of 10px on the screen.
For example, the four blocks are #000000, # a1a1a1, # 4d4d4d, and # d6d6d6 respectively from top to bottom.
Next, use the self-built brush method learned in the previous chapter to change the image into a brush.
02
Use line (shortcut key \) to pull out a line segment,
Set fill to none, and stroke to # ff0000
And the width of the self-built brush set to 10px.
The effect of applying a brush is as follows:
Use the same method to create another line segment and set stroke to #006d78
03
Then use the pen tool shortcut key (p) to make the two line segments feel stacked up and down
Between the online segment and line segment, add several nodes such as the sample image
04
Use scissors (shortcut C) to remove the line segments between nodes, and pull the separated line segments to the appropriate seats.
This looks like the overlap of the two lines in this area. The green line is above.
05
Let's add a shadow effect.
Drag a square with the width and height equal to 10px and opacity60 %
Fill uses gradient layer effects: (from bottom to bottom)
1. Color Order position 0%, #000000, stop Alpha 100%
2. Color Order position 51%, #585858, stop Alpha 61%
3. Color Order position 100%, # ffffff, stop Alpha 0%
Multiple vertex workers are placed on the intersection, such
Is this more effective?
In the same way, place a shadow effect on multiple meeting points ~!
Attached example:
If you can use design, it will bring you twice the result with half the effort!
This is the teaching of this article.