Next we will mainly explain how to solve the fault through DHCP scope. My school has two data centers. The computer in data center A is A specified IP address, and the computer in data center B uses the DHCP service to automatically obtain the IP address. When the two data centers use and access the Internet at the same time, some computers often fail over the network and the speed is slow ).
Cause Analysis
Each time data center A with the specified IP address is enabled, all computers in the data center can access the Internet normally. If DHCP is automatically obtained, data center B with the IP address is enabled first, in this case, the IP address of data center B conflicts with the IP address of the computer in data center A, causing some> computers to be unable to access the Internet. Therefore, I decided to leave a specified IP address segment in the DHCP scope of data center B to avoid IP address conflicts.
Solution Process
After resetting the DHCP scope, I did not restart the Windows 2000 Server System). As a result, all the computers in Server room B cannot access the Internet. In the beginning, it was thought that the access line was faulty, but the test instrument was used to detect it normally. it was suspected that there was a problem with the hub hardware and that it was caused by a broadcast storm caused by hardware damage. After the hub was changed, the fault remained; consider whether there are redundant lines that constitute a loop, so that data packets are constantly sent and verified, leading to the inability to access the Internet. The author immediately removes all connections to ensure that no loop is formed, there is still a problem that only one hub is configured for data center B. When I feel exhausted, I accidentally restart the server and the problem is solved immediately.
Summary
When the specified IP address conflicts with the IP address obtained by DHCP, and some computers cannot access the Internet, the specified IP address segment should be reserved in the DHCP scope to avoid repeated IP addresses; after the DHCP scope is reset, all the computers in the machine room that use DHCP to automatically obtain the IP address cannot access the Internet, because Windows 2000 Server has not restarted, it can be seen that the Network Setting in Windows 2000 Server does not need to be restarted to take effect. In addition, the gradual division is also a good way to solve similar problems.