Feeling for the teacher in the installation and removal

Last week, we joined the 9-phase students to perform machine disassembly and Assembly Learning. After a year, we did not study as a student, but appeared as a teacher and a master. Throughout the process, I was filled with laughter and got a rare opportunity to exercise.

We were notified one week in advance that we were going to teach 9 lessons on computer hardware and disassemble machines. We prepared a lot of materials on the materials and read a lot of magic books, select an antique computer that can run in the IDC. In this day's teaching, it is not easy to simply need a little knowledge. If you have the knowledge, you will not be able to express it well.

I brought Sun Yang, Shi bingjie, and Wang Jingjing. Everyone has mastered the knowledge in the magic book, but it is not very good. It may also be difficult for us to answer some questions. However, I am quite satisfied with these three students. In general, the whole process of machine assembly and assembly has always been emphasized for them to observe carefully, but what they do is not in place, and they are very anxious, they can perform their own disassembly and assembly machines as quickly as possible to complete the task. But in many details, they don't know where to start. The whole process is not fast, and they have not achieved their goal. In other aspects, they are doing quite well. Observe every detail on the motherboard, every chip, every word, and ask or write down the questions to check.

In fact, although we learned from them throughout the process, we did not get much less than them. Everyone never realized that the process of understanding, the arrangement of one day of study, and the explanation of knowledge need to be well grasped by themselves. Otherwise, this opportunity will be a big failure process.

There will be another system installation learning process next week. Learning will continue ......