Figure 1 configuration of Huawei switch 3528)

As the access layer switch of our company, the Huawei 3528 switch must be configured when it is activated for private network services. Next I will introduce the configuration method of the Huawei 3528 switch in combination with a specific network activation project.

1. Connect to the vswitch through the Configuration Port

1. To establish a local configuration environment, you only need to connect the serial port of the laptop to the Console port of the Ethernet switch through the configuration cable.

Figure 1 connect to a vswitch through the Configuration Port

Run the Super Terminal Program on the laptop, select the serial port connected to the switch, and configure the communication parameters of the terminal as follows: the baud rate is 9600bit/s, 8-Bit Data bit, 1-bit stop bit, no checksum and no traffic control. Figure 2, figure 4, and then enter the logon password to log on to the vswitch.

Figure 2

Figure 3

Figure 4