2013 New Macbookpro installation osx10.10 and Win7 dual system lossless multi-partition

Refer to the following blog posts:

Http://www.cnblogs.com/dolphin0520/p/3669479.html

Http://blog.sina.com.cn/s/blog_3e71da2201019ivk.html

Http://www.iplaysoft.com/osx-yosemite-usb-install-drive.html (French one, make OSX10.10 start USB drive)

Http://jingyan.baidu.com/article/c85b7a640185d3003bac9526.html (FA two, make OSX10.10 start USB drive)

Http://wenku.baidu.com/link?url=2d3bcGekeVmtJu0QBh0L13xra5wBNW766sT-2NCHur64jQY-E7Cdhmz_ 3clskhiyd9uhdjk8qn3goslwocx7spkon6a86qpwrx3i6txziyu (FA III, make OSX10.10 start USB drive)

2. Insert a USB flash drive, power on the Changan option key, after selecting the interface of the startup item, select the USB flash drive, select the Disk tool after startup, select the hard drive and erase, then click Partition to re-partition the system, select 3 partitions, each partition information as follows:
   

   1) d:80g MS-DOS (FAT) format
   

   2) c:60g MS-DOS (FAT) format for Windows system installation in this partition
   

   3) Macintosh remaining space Mac OS extended (journaled) for Mac system installation

   There are also 200M of EFI hidden partitions that cannot be deleted and can be seen after entering WinPE
   

4. After partitioning, exit the disk utility, install the MAC system to the last partition, the Macintosh, until the installation is complete!

6. Download the corresponding bootcamp driver to the USB flash drive according to the production date of the model

   https://support.apple.com/zh-cn/HT5634
   

8. Install the Win7 system, power on the Changan option key, select the USB flash drive, enter the WinPE system, format the C drive as NTFS, and then
   

   1) Law one: Insert the Win7 installation disc, and in the Where do you want to install Windows, reformat the C drive (60G) and load the appropriate keyboard, touchpad driver: Load driver-Browse-->bootcamp\drivers\intel\ Chipset\win7--> OK, locate the Intel (R) 8 series/c220 series SMB Controller-9c22, tick the check box to hide this computer's incompatible driver, install it according to the normal process, After each reboot, press the option key to select Win7 to start until the Win7 system is installed.

   2) Law II: Enter the WinPE system, load virtual image, install the original WIN8 Enterprise Edition, after the use of NT6 HDD Installer, restart the system after the Win7 installation interface, followed by the same steps as law two. (This method in the case of forgetting to use the CD-ROM, if directly into the PE installation win7 64, after installation, the first reboot into the Win7 when the touchpad keyboard is not available)

10. Install the third step download good boot Camp driver.

12. After the installation is restarted, enter the Win7 system to open bootcamp, select the Startup disk, select the default boot system, after which the system starts this system every time.
    

    
    

2013 New Macbookpro installation osx10.10 and Win7 dual system lossless multi-partition