Development Board is the development and learning of embedded technology, the main hardware equipment, development Board models and types of many, the current popular is based on the s3c6410 ARM11 Architecture Development Board, S3C6410 is a low-power, cost-effective RISC processor introduced by Samsung, based on the ARM11 core, It can be widely used in the fields of mobile phone and demon processing.
OK6410 Development Board based on Samsung's latest ARM11 processor s3c6410, has a strong internal resources and video processing capabilities, stable operation at 667MHZ above the frequency, Support MOBILEDDR and a variety of nandflash.ok6410 boards integrate a variety of high-end interfaces, such as composite video signal, camera, USB,SD card, LCD screen, Ethernet, and equipped with temperature sensors and infrared receiver first class, using the OK6410 Development Board can also be used in other ways the actual Linux driver output Debugging information, this is the serial communication. In this chapter, the Minicom Serial debugging tool is introduced in detail.
First step: Detect whether the current system supports USB to serial port
Step Two: Install Minicom
Step Three: Configure Minicom
Fourth step: Detect Minicom
Before burning the Android system, you need to use Eboot to erase the Nandflash, as follows:
The first step: getting Ready for work
Step Two: Enter the Eboot state
Step Three: Erase Nandflash
The steps to burn Android are as follows:
The first step: getting Ready for work
Step two: Write Mmc.bin and ZImage.sb.bin to SD card
Step three: Prepare to burn and write before Android
Fourth step: Start burning from SD card to write Android
Fifth step: Calibrate the screen
This chapter is really about installing Android on the OK6410 board. http://home.cnblogs.com/u/zivjeli/
Android Deep Exploration (Vol. 1) Hal and Driver Development Fifth Chapter summary
