Apple Mobile Device (Recovery Mode) driver installation

There is a connection to the itunes icon on the screen, when the computer prompts to discover new hardware "Apple Mobile Device", Pop-up prompts box to install the driver, click Automatic Search fruitless, drive installation failed, the computer does not recognize the recovery mode of iPad2, pain. (also appeared when IPhone4 was upgraded)

Then itunes prompts 1602 error. is not a lot of peak friends have seen. The solution is then searched on the network. Many hints that the "Apple Mobile Device" service is not turned on. The result is a look, the service is turned on, and the new hardware is not recognized when it is stopped and opened more than once.

Pondering over and over again, in the Niang search to an article by Peachglide share article, mentioned is actually drive failed to install caused, gave the solution. Go home and try to solve the problem, close-up out to share with you.

Background:

System: Windows XP SP3

Apple Mobile Device Service is open

First, when the device is in recovery mode, do not recognize the hardware, the main computer in the "Apple Mobile Device USB Driver" driver is not installed.

Second, to the hardware installation drive

1, Connect hardware (IPAD2), computer prompts to find hardware "Apple Mobile Device", ignored.

2, open the computer Device Manager, found that there is a yellow question mark hardware is not recognized, ignore.

3, point open "Universal Serial Bus Controller", see the following figure

"Apple mobile Device USB Driver" is not displayed on everyone's computer, but it shows 2 "USB Composit Device", one of which is "" "Apple mobile Device USB Driver".

4, install the driver, find the property is "Apple" "USB composit Device", point "Update Drive", pop-up dialog box, select the following one, see figure

5, appear the second dialog box, the same choice of second, see figure

6, select "Apple Mobile Device USB Driver", see figure

7, after that is the next step to the end.

8. To this end, the driver installation is complete, you can update the firmware normal.

Reflection: When the system is directly prompted to install the driver, is it possible to do so directly? My installation is ready, only waiting for everyone to try.