Arduino Uno Laser transmitter and receiver module sensor applications

Laser Tube Transmitting module & Laser receiving module

Experimental Results

BOM List

Arduino Uno * *

Laser Tube Transmitting Module * *

Laser Receiving Module * *

Bread Plate

Jumper several

Wiring

Arduino Uno <------> Laser Tube Launch module

Pin <------> S (signal pin)

5V <------> +

GND <------>-

Arduino Uno <------> Laser Receive Module Pin 2 <------> out 5V <------ > VCC GND <------> GND

Open Source Code

int LED = 13;                      Defines the LED pin as 13 (i.e. the LED light on the board) int lasersensor = 2;                 Define the laser receiver module signal PIN is 2 int sensorreading = high;                           Defines the laser receiver module signal pin for high-level int Laser = 12;                   Define the laser emission module signal PIN for the Void Setup () {//Put your setup code here, to run Once:pinmode (LED, OUTPUT);                 Define LEDs for Output mode Pinmode (Laser, Output);            Define laser for Output mode Pinmode (Lasersensor, INPUT);             Set to Lasersensor for input mode} void Loop () {//Put your main code here, to run Repeatedly:digitalwrite (Laser, high);                            Laser beam delay (200) is sent to laser high level.  Delay 200 ms Sensorreading = Digitalread (lasersensor);                      Read the current state of the Lasersensor (laser receive module signal PIN) if (sensorreading = = low)//if equals level {Digitalwrite (LED, high);                      The light is lit (something is blocked between the transmit and receive)} else {Digitalwrite (LED, low); Otherwise the light is off (no obstructions between transmit and receive)}}