Belkin route settings Wireless Network

In the process of using wireless networks for Belkin route settings, a slight error occurs, which may cause various faults and affect the normal internet access efficiency. The following are several fault examples, to describe the key aspects of setting up the wireless network.
1. the wireless network is very difficult. Open the webpage slowly www.2cto.com 1. If we find that the network is very slow when using the wireless network, we need to confirm whether it is the website card you want to access, you can try to open another website, or use Wired Access to try again. 2. If the wired network is normal and the wireless network card is used, it is caused by weak wireless signals, which is the main cause of weak wireless transmission signals, the biggest possible reason is that the wireless router device's connection location is not properly placed. Try to place the wireless router device in a relatively high location, preferably in the middle of the house, instead of using the wireless network through the wall, because cement walls can block most signals.
2. Unable to log on to the vro1 through wireless connection 1. There are many reasons for the failure of the wireless router to log on. First, check whether there is a hardware fault, observe the signal lights in the control panel of the wireless router to quickly determine whether the device has a hardware-related wireless network fault. 2. Check the IP address of the local machine when the wireless router is confirmed to be normal. It is best to set the IP address to be automatically obtained to ensure that the IP address is in the same CIDR block as the wireless router and try to disable the firewall function. Www.2cto.com 3. If you still cannot log on, try to modify the IE settings, open the IE browser window, and execute the tool-Internet option in sequence in the menu bar of the window, in the pop-up Internet option settings window, click connection. No dial-up connection is selected, click LAN Settings, and all options are cleared on the settings page, then you can log on to the wireless router.
3. Network disconnection and disconnection from time to time. 1. The computer often fails to access the Internet for a while and cannot access the Internet for a while. First, check whether the connection parameters with the wireless router are set correctly, check whether the connection method of the wireless router is correct and whether the on-demand connection is used. When data is accessed, the router automatically connects to the connection mode. If the router does not check whether there is data interaction in the line, it will automatically disconnect the connected wireless connection line. 2. Change the connection mode to automatic connection, and enable automatic connection after startup and disconnection to solve intermittent network disconnection in the wireless network. 3. check whether there is a virus. When there is an ARP virus in the Intranet, the Network may also be good or bad. In this case, we can use anti-virus software to check every computer in the intranet, find the computer with the virus, disinfect the virus, and restart the entire network to solve the problem.