Brocade vswitch configuration Manual

The Brocade series of products generally have default configurations at the factory. They can be used normally as long as they are started, But zones are usually divided on the switch.

, The settings are described in detail below.

1. Connect to the vswitch through IE browser (premise: the Java Plug-in is installed)

Open IE, enter the IP address of the switch in the address bar, press enter, and enter the administrator username and password to log on. The default username is admin and password is password. The interface is shown in Figure 1)

Figure 1

2. Click Zone

Admin to go to Figure 2:

Figure 2

3. Select the first switch/port level Zon ..., Click OK to go to the page (Figure 3)

Figure 3

4. Click port zone.

Enter port zone

First, create Zone

, Enter Zone

Name, double-click the port number to append to the members member, click Apply after the append, a zone

Created successfully. Create other zones in the same way

.

5. Click port confige to go to Figure 4:

Figure 4

6. Click Create CFG, enter the CFG name, and add the required zone to FC members.

, Point

Click Apply.

7. Click Enable confige, 5

Figure 5

This zone

After the configuration is complete, the switch can be used normally.