Buffalo wzr-hp-ag300h Brush OpenWRT firmware (2014.07.03 version)

version.2014.07.03

Introduction to the online brush machine tutorial, TFTP client is mainly Linux, Windows 7, Windows XP. There is no suitable Linux computer at hand, Windows 7 without TFTP client, lazy toss, found a Windows XP computer.

Therefore, the following environments are the basis for:

L Buffalo wzr-hp-ag300h Wireless router;

L A fool switch (broadband router also line, only use the LAN port), this function is to keep the computer's network port up state;

L OPENWRT firmware, file name: "Openwrt-ar71xx-generic-wzr-hp-ag300h-squashfs-tftp.bin";

L Microsoft Windows XP SP3.

First, only one RJ45 port card is left on the Windows XP computer, and the other network cards are disabled. Set the IP address of the network card as follows:

L Static ip:192.168.11.2

L Subnet Mask: 255.255.255.0

L Default gateway: 192.168.11.1

L dns:192.168.11.1

Then set the static route table, and in the Command line window enter:

Arp-s 192.168.11.1 02-aa-bb-cc-dd-20//Where 02-aa-bb-cc-dd-20 this MAC address is the Buffalo default MAC address of wzr-hp-ag300h Uboot wireless router

You can use the command arp-a to view the results, confirm 192.168.11.1 This IP address and 02-aa-bb-cc-dd-20 binding, the beginning of the third step, in the Command line window input:

Tftp-i 192.168.11.1 PUT Openwrt-ar71xx-generic-wzr-hp-ag300h-squashfs-tftp.bin

(Note: Do not enter here, just input is finished.)

Fourth step, give the router power on the start of the time, 10 seconds after the Command line window press ENTER, regardless of the network connection icon.

Probably less than more than 10 seconds, prompt transmission success: Transfer successful:2949156 bytes in 9 seconds, 327684 bytes/s

At this time do not do anything, the router itself will restart, about more than 10 minutes, the red light does not flash. Then set the computer network card IP address is:

L Static ip:192.168.1.2

L Subnet Mask: 255.255.255.0

L Default gateway: 192.168.1.1

L dns:192.168.1.1

After restarting the Buffalo wzr-hp-ag300h wireless router (which should be brushed to openwrt at this time) the IP address is 192.168.1.1. Use the browser to access 192.168.1.1, return to the login page, prompt to change the password.

Finish the job ...

Buffalo wzr-hp-ag300h Brush OpenWRT firmware (2014.07.03 version)