Capacitive screen drifting, the screen is inexplicably messy

My mobile phone broke down for 2 days and finally got it ready !!! My mobile phone is on the left with a weight of 1 cm !! Solved this afternoon !!! Let's take a look !!! Capacitive screen floating solution: solution 1: Turn off the phone, take out the battery, hold the phone for about five minutes, or place it overnight to find a USB data cable, connect the phone to wash your hands, or wet your hands (key steps, in order to better export the static electricity) in the wet hand state, the thumb of the same hand is in contact with the metal part of the other end of the USB line, and the index finger is pressed to the ground for about two seconds (initial power removal) split the back cover and we can see a small metal block next to the battery compartment. This is the generator of the vibration of the mobile machine, commonly known as the vibration. Because it is also directly connected to the mobile phone motherboard, we can do this. In the wet hand state, the thumb of the same hand is in contact with the earthquake, and the index finger is pressed to the ground for about two seconds. Solution 2: Recently, the screen is always drifting, that is, the screen is inexplicably confused and inaccurate. monitoring is not a Rom, but a physical cause. The following is an analysis. With the help of the electric iron, I have solved this problem and hope to help the oil that encounters this problem. Method: remove the hd2 battery, power-on the electric iron, and press the sheets on the sheets. The temperature should be moderate, enable the iron, and buckle the hd2 screen to the hot sheets, burn the screen (the temperature must be moderate, not repeated), so it is repeated about five times. Solution 3: there is an article on the computer report to solve the screen drift. Blow the screen with a hot air (blow the hair), pay attention to drive to the middle gear, and even feel the screen is hot (Note: remove the sub-battery) Solution 4 electric shock method: Use the static electrical appliances in the lighter to shock the screen, change the electric field, not all are applicable, everyone should be careful! Solution 5: Place the mobile phone screen on the floor. This method can be used in the test.