En
Conf t
Clock timezone gmt+8 #设置北京时间
Exit
Clock set HH:MM:SS Day MONTH #设置当前时间
Service Timestamps Debug Uptime #开启debug调试模式
Service Timestamps log datetime localtime #开启log日志增加时间戳
Log on #启动log功能
Loggin 192.168.1.100 #配置日志发送到192.168.1.100 on the host
Loggin facility Local2 #将记录时间类型定义为local2
Loggin Trap 7 #cisco device alarm level is divided into 0---7 levels, 0 levels highest, 7 level lowest
Logging Source-inter loopback0 #指定log日志记录内容发送的源地址为Loopback0的IP地址
Service Timestamps log datetime localtime #发送log日志时发送时间戳
End
wr
--------------------------------------
Severity level of log messages
Parameter level system Log description description
Emergencies 0 Log_emerg System not available
Alerts 1 Log_alert is required for immediate operation under the port
Critical 2 A critical state exists on the Log_crit router
Errors 3 An error state exists on the Log_err router
Warnings 4 A warning state exists on the log_warning router
Notifications 5 a common but important event occurred on the Log_notice router
Informational 6 An informational event occurred on the Log_info router
Debugging 7 Log_debug output from the DEBUG command
Configuration on the switch
C3560#config T
C3560 (config) #logging on
C3560 (config) #logging the IP address of the 10.86.20.10//log server
C3560 (config) #logging facility local0//facility identity
C3560 (config) #logging trap 3 (log log)//logging Level
C3560 (config) #logging source-interface G0/3//Source IP address for log emit
C3560 (config) #service timestamps debug datetime localtime//log record timestamp settings, which can be configured as needed
C3560 (config) #exit
View C3560#show Logging
This article from the "Moon Empty" blog, please be sure to keep this source http://13001500368.blog.51cto.com/2905946/1875780
Cisco device logs sent to the log log server