Cisco FAT AP Configuration Online

In this article, the article next morning, on the Cisco AIR-SAP1602I-C-K9 this AP in the state of the FAT AP configured to surf the Internet in a step-up experiment. The configuration is divided into two parts, the first part can be configured in the CLI state of a management IP, the role of the IP is to manage, and LAN is not the same network segment, but also in the same network segment, it does not affect users to surf the internet, but if not the same network segment, the use of remote Web can not be managed. The second step is to create the SSID in the Web state, turn on the wireless band, set the encryption method and password, and so on.

One, configuration management IP address

ap>en

Password:

Ap#conf T

AP (config) #int BVI 1

AP (config-if) #ip address 10.0.0.1 255.0.0.0

Two, login to the management address 10.0.0.1, user name Cisco, password Cisco

Third, configure the SSID, security and other information.

1. Set SSID Easy Setup-network configuration

Fill in the SSID name, check the broadcast SSID, and leave the remaining default.

2. Turn on the wireless function: Network-network INTERFACE, radio0-802.11n 2.4GHz and radio1-802.11n 5GHz are set here.

A. By default, it is not turned on,

B. On this page, click Setting, select Enable Radio here, and click Apply in the lower right corner.

C. Then, return to radio0-802.11n 2.4G status and view the status, and you can see that the soft status becomes the Enabled,hardware status to up. This enables the wireless capability of the 2.4G band.

3. Encryption settings

Security-encryption Manager, opening cipher to AES CCMP at 2.4G and 5G respectively

4. Set Password: In Security--ssid Manager here, choose to start creating a good SSID, on the right side of the interface check the application frequency band, if only apply to 2.4G only tick 2.4G, if applied to two bands, tick together. If you want to apply to two bands, as soon as the first step is created, just create an SSID, such as the name Cisco, and here I am the Cisco _2.4g, just represent the name, you want to create 2.4G and 5G SSID different, you can create this. I only create one SSID here, applied to two bands.

In the client authenticated key management here WPA pre-shared key enter your password here.

5. Turn on the 5G band, as in the 2nd step.

6. Connect the network port of the AP to the local area network, and the client can surf the internet properly in the case of DHCP.

Cisco FAT AP Configuration Online