Cisco emulator Configuration DHCP

650) this.width=650; "src="%5c "title=" \ "DHCP. Jpg\ "/" alt= "wkiol1b1pb_rx6iyaacdaqbsyjm639.jpg\" "/>

The first step is to configure the port f6/0 on the router connection PC0 to 172.16.14.1, the port f0/0 of the connection switch is configured to 172.16.13.1, the port f1/0 the connection server is configured to 172.16.10.2.

On the code:

int f6/0

IP address 172.16.14.1 255.255.255.0

int f0/0

IP address 172.16.13.1 255.255.255.0

int f1/0

IP address 172.16.10.2 255.255.255.0

OK, at this time the gateway for different network segments is already well-equipped.

The second step is to configure the DHCP service for the server,

Start the service "on" and add the address pool Serverpool and Extralpool,

650) this.width=650; "src="%5c "title=" \ "3.jpg\"/"alt=" wkiom1b1pylwl5j9aajzxqmygjm010.jpg\ "/>650" this.width= 650; "Src="%5c "title=" \ "4.jpg\"/"alt=" wkiol1b1ptrz-uouaajnsbtnijg465.jpg\ "/>

In the third step, the router is configured to configure "IP helper-address 172.16.10.2" to three ports in turn.

After configuration, set several PCs to get IP address dynamically, you will find that obtaining the IP address is successful,

650) this.width=650; "src="%5c "title=" \ "5.jpg\"/"alt=" wkiol1b1p_qsnyqlaahkwo8fjii815.jpg\ "/>

650) this.width=650; "src="%5c "title=" \ "6.jpg\"/"alt=" wkiom1b1p6qhdkvsaagmtjypyxk366.jpg\ "/>

As a result, the experimental results have been achieved.

Note: The IP helper-address in the simulator means that an IP address is specified for UDP broadcasts.

Cisco emulator Configuration DHCP