Cisco simulator simple network connection operation

Cisco simulator simple network connection operation

To complete the following steps: 1. configure the IP address and gateway of the PC first. activate the corresponding interface of the switch (the Cisco simulator is automatically enabled, so you do not need to activate it here) 3. start by adding IP addresses and static routes to the vro. Step 1: double-click the PC2 host in the figure. On the configuration page, configure the remaining five PCs, here we will not explain one by one, just like the operation in PC2, but the IP address and gateway are different Step 2: configure the switch. This experiment does not require Step 3: configure the router, double-click the router icon, enter the third menu, enter the configuration interface, and then configure (Note: before the operation, open the Cisco simulator menu bar, find Options, click it, and select the first item, check the fifth line and display the device interface number.) After the interface number is displayed, you can configure the router. Double-click the router to be configured, select command line here to explain the parameters of static routing configuration (for example, in reality, configure the corresponding ip address) ip route for the configured command 192.168.2.0 The next CIDR Block 255.255.255.0 is the subnet mask 10.0.0.2 of the CIDR block to be reached. 10.0.0.2 is the vro interface required to arrive at the next CIDR block. The second vro is not explained here. It is verified in the same way as the first, can the ping test end ~ Thank you for your support.