Common faults in computer memory and methods of solving them

Common fault One: no display on the boot

Memory is the reason for this type of failure is usually due to the memory and the motherboard memory slot caused by bad contact, as long as the eraser back and forth to wipe the gold finger parts can solve the problem (do not use alcohol and other cleaning), there is memory damage or motherboard memory slot problems will cause such a fault.

The host speaker will generally beep for a long time (for the award BIOS) due to a memory-strip cause of boot-free failure.

Common fault Two: Windows registry is often damaged without cause, prompting for user recovery

Such failures are generally due to poor quality of memory, it is difficult to repair, only to replace one way.

Common fault Three: Windows often automatically enter Safe mode

This type of failure is typically caused by a motherboard that is incompatible with memory strips or with poor quality of memory strips. Common in high frequency memory for some motherboards that do not support this frequency memory, you can try to reduce the memory read speed in the CMOS settings to see if the problem can be solved, if not, then only replace the memory bar.

Common fault four: random panic

Such failures are generally due to the use of several different chips of the memory, due to the different speed of each memory to produce a time difference resulting in a panic, this can be in the CMOS settings to reduce memory speed to be resolved, otherwise, only the use of the same model of memory. There is also a possible memory is not compatible with the motherboard, such a phenomenon is generally rare, but also may be the memory and motherboard contact bad computer random panic.

Common failure Five: after the increase in memory system resources decreased

This type of phenomenon is generally due to the motherboard is incompatible with memory, common in the high frequency memory memory for some of the motherboard does not support this frequency of memory, in the case of such a failure you can try to coms the speed of memory set to try to lower.

Common fault Six: running some software often appear low memory tips

This phenomenon is generally due to the system disk space is not enough, you can delete some useless files, more space can be left, the general stay in the 300M or so advisable.

Common failures Seven: when booting from the hard drive to install Windows to detect disk space, the system prompts for insufficient memory

This type of failure is generally due to the user in the Config.sys file added Emm386.exe file, as long as it can be shielded to solve the problem! Bathers PC235 Feeds