Configure a CISCO secondary route

For the majority of network administrators, it is common to set a secondary router in the network. Today, I will explain how to set a secondary router, A vro is a direct subordinate of a level-1 router, and the IP address assigned to it is dynamic or solid. 1. log on to the vro1 and enter the routing configuration interface. 2. Change the address of the second-level route you want to configure to be different from 192.168.1.1. Suppose it is 192.168.10.13 or WAN. Here we assume that the Internet access mode is fixed IP, 192.168.1.106, subnet Mask 255.255.255.0 and gateway 192.168.1.1. Www.2cto.com 4. Some networks use clone MAC addresses. Of course, it is generally not needed. 5. Change the computer to 192.168.10.2, subnet mask 255.255.0, and gateway 192.168.10.1. 6. The first-level router receives the WAN port and the computer network cable is plugged into the LAN port. The setting ends. If you connect any LAN port of the wireless router to the LAN port of other routers, you can use the wireless router as an AP. 2. As vswitch 1, the IP address of the LAN port of the first vro is set to 192.168.1.1 subnet 255.255.255.0. 2. enable DHCP and enter the IP address range from 192.168.1.100 to 192.168.1.199. 3. Set the IP address of the LAN port of the first router to 192.168.1.2 subnet 255.255.255.0. 4. disable DHCP for the second router. All IP addresses of the computer are automatically obtained.