Connect to the FAST router through a cat

If you want to connect to the Internet through the LAN of the FAST router through a cat, the main device is the router. A router can be divided into a wired router and a wireless router. The biggest difference between the two is that a wireless router not only has a WAN port, but generally has four LAN ports to remove the wireless function. It is a wired four-port router, wireless AP has only one WAN port, and it only implements wireless coverage. Www.2cto.com
1. First, find the antennas from the accessories and install them on the vro. If they are not detachable antennas, this process will be free of charge. select a suitable location for the wireless router. There are three factors to consider: First, try to use wireless signals to cover the middle of all users, so as not to lose sight of each other and deprive some students of the right to access the Internet. Second, it is to consider the location of your upper-level access point, such as the upper-level router or adsl cat (home users), close to them, so you don't need to pull the network cable. Www.2cto.com 2. After the wireless router is placed, plug in the dedicated power adapter in the accessories and turn on the power, the router will start. However, the vro cannot access the Internet at this time. You need to make some settings to use the vro. After the vro is installed, set the vro below. Your Wireless Router usually has two access methods. 3. The access method to connect the upper-level router is common in the company's internal network, and the access method to connect the modem is mainly used for home broadband access, such as China Telecom ADSL. If your access method is the first, make sure that the LAN interface IP address of the connected upper-level router cannot conflict with the LAN interface IP address of the wireless router. For example, the upper-level router uses the IP address 192.168.1.1, And the IP address of the wireless router to be connected is 192.168.1.1, their IP addresses will conflict, resulting in the failure of the wireless router to work normally. The solution is to change one of them to another IP address, such as 192.168.0.1. For detailed settings, refer to the relevant manual. 4. For the second connection mode, make sure that the modem is in bridging mode. If you have already used another vro or a computer to dial up the Internet, the modem is in bridging mode, you do not need to make too many settings. If the modem is used for automatic dialing, You need to reset the modem to the Bridge Mode. For more information, see the relevant manual. Www.2cto.com 5. After the above preparations are completed, connect the WAN interface of the wireless router with the network cable and the upper-level router and modem. Then you can set the router. First, you need to go to the router settings page. You can use the network cable attached to the accessories to connect to any LAN interface of the wireless router or directly connect to the wireless router using a wireless network. The default wireless network name and key are marked on the back of the fuselage, for example, SSID: 3052D0 and key: 451254067703. After the connection is successful, open the browser and enter: http://192.168.1.1 To go to the router settings home page. Now that you have already entered the vro, I believe that everyone knows how to do it. Here we will not be talking about it, you can check the settings of the Alpha router.