Dell Switch Configuration Link Aggregation

5. Configure link Aggregation

Description: DELL 5524 switches can be used to create link aggregations manually, or you can use the LACP protocol for link Clustering

Hop. Switch 19-20 port set to static link aggregation, 21-22 Port set to LACP dynamic Link aggregation.

DELL 55xx series switches can only be created by default + 8 Span style= "Font-family:simsun;" lang= "en-us" xml:lang= "en-US" > ports. Because

This static link aggregation uses the group 1 , while LACP Link Aggregation using groups 2

5.1. Creating a static link aggregation

console# configureterminal

Console (config) #interface range gigabitethernet 1/0/19-20

Console (config-if-range) #channel-group1 mode on

Console (config-if) #end

console#

5.2. Creating an LACP dynamic Link Aggregation

console# configureterminal

Console (config) #lacpsystem-priority 120

Console (config) #interface range gigabitethernet 1/0/19-20

Console (Config-if-range) #lacpport-priority 247

Console (Config-if-range) #lacptimeout long

Console (config-if) #end

console#

Set the properties, start creating the aggregation group below

console# configureterminal

Console (config) #interface range gigabitethernet 1/0/21-22

Console (config-if-range) #channel-group2 mode auto

Console (config-if) #end

console#

6. Open Ports flowcontrol ,spanning-tree, and port-fast

Description: Spanning-tree Mode in DELL 5524 The switch is turned on by default, RSTP mode. So this is only

tell me about open ports FlowControl with the Port-fast

6.1. turning the flowcontrol function on or off

the following to configure the port 1 For example

console# configureterminal

Console (config) #interface gigabitethernet 1/0/1

Console (config-if) #flowcontrol on

Console (config-if) #end

console#

Close FlowControl The following actions are

console# configureterminal

Console (config) #interface gigabitethernet 1/0/1

Console (config-if) #flowcontrol off

Console (config-if) #end

console#

Note: Restart the port. If it is a bulk port, use the range command

6.2. turning the port-fast function on or off

the following to configure the port 1 For example

console# configureterminal

Console (config) #interface gigabitethernet 1/0/1

Console (config-if) #spanning-tree portfast

Console (config-if) #end

console#

Close Port-fast The following actions are

console# configureterminal

Console (config) #interface gigabitethernet 1/0/1

Console (config-if) #no spanning-tree portfast

Console (config-if) #end

console#

Note: The port used for link aggregation does not open Port-fast . If it is a bulk port, use the range command

7.iSCSI Mode

DELL The switch now has ISCSI optimize the configuration function, the following is the open ISCSI Mode

console# configureterminal

Console (config) #iscsienable

This article is from the "BOM water Year _" blog, please be sure to keep this source http://timefiles.blog.51cto.com/8475652/1590910

Dell Switch Configuration Link Aggregation