Setting up from IPMI Virtual Disk 3000, the following interface appears:
By default Select the first item, enter install
Setup is detecting server hardware information and will jump out of error if the system installation conditions are not met.
The following interface appears after detection is complete
Enter
Press F11
The server hard disk information is listed here, the default carriage return, the following interface appears
Enter
Keyboard mode, default, enter
Server root account password settings (note: password length more than 7 digits)
Press F11 to start the installation
Installing in progress
After the installation is complete, the following interface appears
Install complete, eject image, enter reboot system.
The system is rebooting
Set up hard drive boot
The system starts and the ESXi is set up below
Press F2 to appear below the interface
Enter the root password, return
Switch to configure Management network option, enter
The following interface appears
Select IPv4 Configuration Carriage return
Select the third item with a space, set to static IP
Enter the corresponding IP, subnet mask, gateway information return
Continue to select DNS Configuration carriage return
With empty Gueyang The second item, use the custom DNS, fill in DNS, Hostname modify the name you want
Enter
Press ESC, enter Y to save the configuration information above
Continue to press ESC to return to the main interface
Press F12 to restart the system
Enter the root password return
Press F11
System is restarting
After rebooting, the following interface appears
At this point, the VMware ESXI 6.5 installation is complete,
Choose a different NIC
ESXI 6.5 Installation