Flash Dynamic Effect: the effect of paper

Dynamic

For this effect, it took almost one night. Although it was later produced, the implementation is also very simple. But the method is to come up with a sense of achievement. This special effect is difficult to implement. It's not hard to make. Limited to personal ability, the explanation may not be very clear. Please combine the original document so as to facilitate understanding.

　　Effect 1:

Click here to download the source file

　　Effect 2:

Click here to download the source file

　　Production steps:

Create a new Flash document,

Press Ctrl+f8 to create a new component and import the picture. Open the library. Pull the component into the scene, create a new layer 2, copy the Layer 1 component to Layer 2. Hold down ALT and pull the frame on layer 1 directly onto Layer 2. Now two layers of components are shown in the figure

Because we do is the effect of paper. So to mold to prevent the effect of the book. It is clearly wrong to look at Figure 2. Select the symbol on the left

Flip horizontally as shown in the figure

That's logical. If you don't know how to flip, you can take a piece of paper to imitate the effect. Later you will find that if the imagination is not good enough. It is necessary to imitate it with a paper mould. Dot Layer 2 on the component, in the property bar color-advanced-settings-as shown in the figure

The next steps are a bit of a draw. That I had to get a night to find some rules, suggest a piece of paper to imitate the effect.
Insert a frame in layer 1, 20 frame, flip the component on Layer 2

Now I give you some of the rules I have come to explain that the paper effect in Flash can be achieved by the symmetrical method

After mastering the principle, everything becomes very easy. We suggest that you click on the timeline

Tick, so everyone is looking for the middle of the line is more convenient

The following illustration is a screenshot of two components in some of these keyframes:

Inserts a keyframe. A frame-by-frame move position, as shown after completion,

Now let's make a mask, create a new layer on Layer 2, and draw a square. The box must be larger than the component. This allows the component to be completely obscured. The edges of the squares must be on the line where two components intersect.

After the mask layer completes, create a new layer on layer 1. Press ALT on the layer above the mask layer to the new layer. This creates a new layer with the same block as the mask layer. Finally, it is OK to set the two layers as masks.