H3C and CISCO switch for aggregation configuration

I. network environment the network environment is the topic of port aggregation for three vswitches in Guangdong yuedian building: H3C_A vswitch <-----------------> H3C_ B vswitch <----- -------------------> cisco (3560) the H3C_ B switch is a central switch. Due to bandwidth requirements, many well-known American avocentKVM monitoring devices are built on the 9th floor, which requires a lot of bandwidth, therefore, four groups of Port Link aggregation need www.2cto.com. Therefore, the following configuration commands 1 and H3C_A are configured as follows: (Dynamic Link aggregation, LACP is started by default) [H3C_A] sys [H3C_A] int bridge-aggregation 1 [H3C_A] link-aggregation mode dynamil [H3C_A] int giabthernet1/0/26 [H3C_A_giabthernet1/0/26] duplex full [H3C_A_giabt Hernet1/0/26] speed 1000 [H3C_A_giabthernet1/0/26] port link-type trunk [H3C_A_giabthernet1/0/26] port trunk permit vlan all. Therefore, the other three ports are the same, if the above configuration is complete, and H3C_ B is also the same as the H3C_A configuration, the configuration is complete, check the port problems. Www.2cto.com 2. cisco configuration [cisco] int port-channel 2 [cisco] swit trunk encapsulation dot1q [cisco] swit mode trunk [cisco] swit trunk allowed vlan all [cisco] entry port mode configuration [cisco] int gig0/19 [cisco] duplex full [cisco] speed 1000 [cisco] swit trun encapsulation dot1q [cisco] swit mode trunk [cisco] swit trunk allowed vlan all [cisco] channel-group 2 mode other active ports are configured with www.2cto.com configured with dis link-aggregation summary on the H3C switch. At the same time, the Cisco switch uses show ethernetchannel summary to view the information and finally goes through the above configuration, the port aggregation will be available.