H3C switch traffic image

The H3C switch traffic image requires a local traffic image of the switch. In this record, when the vswitch: H3C S5120 configures the local port image, you must first create a local image group, configure the source port and destination port for the local image group. Table 1-1 configure the local port image Operation Command instructions go to the system view system-view-create a local image group using ing-group-id local, which must be selected as the image group configuration source port in the system view configure the source port grouping ing-group-id grouping ing-port-list {both | inbound | outbound}. You can configure multiple source ports simultaneously in the System View, you can also configure the source port in the specific port view, both views have the same configuration effect. In the port view, configure the source port interface-type interface-number [grouping-group-id] routing ing-port {both | inbound | outbound} quit configures the destination port for the image group in the System View. To configure the destination port, which must be ing-group-id monitor-portmonitor-port-id. either of the two views has the same configuration effect. In the port view, configure the destination port interface-type interface. -number [grouping ing-group-id] monitor-port l local image group must be configured with the source port and destination port to take effect. L multiple source ports can be configured in an image group, but only one destination port can be configured. L a port can only be used by one image group. L it is recommended that you do not enable STP, MSTP, and RSTP on the target port; otherwise, the normal use of the device will be affected. L The packets received by the destination port include the packets copied from the source port and the normal forwarding packets from other ports. To ensure that the data monitoring device only analyzes the packets on the source port, it is recommended that the destination port be used only for Port Mirroring without other purposes. 1. Use a PC to connect to the Console port and establish a connection with the vswitch. 2. You can download a Super Terminal Hyper Terminal [plain] system-view in Win7 // enter the system view # display mac-address // display the mac address list. If you do not know the switch port corresponding to the network port, you can obtain # create a local image group through the mac address list. Grouping-group 1 local # configure the source port and destination port for the local image group. Grouping-group 1 grouping ing-port gigabitethernet 1/0/22 both grouping-group 1 monitor-port gigabitethernet 1/0/13 # display the configuration information of all image groups. If you want to modify the source or destination port of the image, use the undo command and add it again. For example, modify the image source port to 1/0/21 undo processing ing-group 1 processing ing-port gigabitethernet 1/0/22 both processing ing-group 1 processing ing-port gigabitethernet 1/0/21 both