H3C telnet Configuration Essentials



First step: Configure username and password in AAA mode
Step Two: Set the user's service type to Telnet
Step three: Set the user's privilege level privileges to 3
Fourth Step: Enter the user interface in System mode User-interface vty0 4
Fifth step: Set the authentication mode of the user interface for AAA authentication Authentication-mode AAA

< If you want to use the loopback address as a Telnet management address >
Sixth step: Configure the loopback address of the device
Seventh: Add a static route with the destination address of the loopback address

AR3260 (g0/0/0)-------AR3260 (g0/0/0)

Cases:

[Huawei]sysname W1

[W1]int g0/0/0
[W1-gigabitethernet0/0/0]ip Add 192.168.1.1 255.255.255.0
[w1-gigabitethernet0/
02/0]4 14:16:46-05:13 W1%%01ifnet/4/link_state (l) [1]:the Line Protocol IP on the interface gigabitethernet0/0/0 Have entered the up state.
[W1-gigabitethernet0/0/0]q
[W1]AAA
[W1-aaa]local-user Huawei Password Cipher Hello
Info:add a new user.
[W1-aaa]local-user Huawei Service-type Telnet
[W1-aaa]local-user Huawei Privilege Level 3
[W1-aaa]q
[W1]user
[W1]user-i
[W1]user-interface vty 0 4
[W1-ui-vty0-4]au
[W1-ui-vty0-4]authentication-mode AAA

[W1-ui-vty0-4]q

Second router

Press Ctrl_] to quit Telnet mode
Trying 192.168.1.1 ...
Connected to 192.168.1.1 ...

Login Authentication

Username:huawei
Password:hello
-----------------------------------------------------------------------------
User Last Login information:
-----------------------------------------------------------------------------
Access type:telnet
ip-address:192.168.1.2
Time:2013-08-24 14:20:59-05:13
-----------------------------------------------------------------------------
<w1>

H3C telnet Configuration Essentials