Specific steps to execute the factory default reset on the switch are:1. Using a small, thin tool with blunt ends (such as a paper clip), simultaneously press both the Reset and Clear buttons on The front of the switch.2. Continue to press the Clear button while releasing the Reset button.3. When all three Mode LEDs (ACT, FDx, and SPD) begin to Blink, release the Clear button. The switch would then complete its self test and begin operating with its configuration restored to the factory default set Tings. Note:after completing this procedure, there would be no password, the IP address would be returned to the default 192.168.2 . Ten, and all configuration settings'll be returned to factory defaults.
Specific steps to perform a factory reset: 1. Use a small, thin tool (such as a paperclip) and press two reset and clear key switches 2. Continue to press the Clear button to release the Reset button 3. When all three mode LEDs (ACT, FDx, ANDSPD) Start flashing, Release the Clear button the switch will complete self-test and begin to operate its configuration and restore factory defaults Note: When this process is complete, there is no password and the IP address will return to the default of 192.168.2.10, all configuration settings will go back to the factory default value
From for notes (Wiz)
HP 1810-24g Switch Reset