HP 360g5 centos7 installation problem, 360g5centos7

HP 360g5 centos7 installation problem, 360g5centos7

How to install HP 360g5 centos7 on the hp Server

I:The boot disk cannot recognize the hard disk.

1. Go to the installation disc and select centos -- Install Centos7 by pressing the up/down key (note that you cannot press Enter ),

2. Press the Tab key to configure the installation. The following words are displayed at the bottom of the screen:

 

3. Add the hpsa. hpsa_simple_mode = 1 hpsa. hpsa_allow_any = 1, on the command line of the additional configuration ,:

　　　　

II:Unable to boot after installation

Cause:CentOS boot progress bar Stuck at 100%

Firmware bug the bios has upted hw pmu resources

2.2 hard disk identification on startup Interface

The Wizard Page is displayed as follows:

 

 

As shown in:

Press e to enter the editing status.

Similarly, type the "hpsa. hpsa_simple_mode = 1 hpsa. hpsa_allow_any = 1" parameter (refer to keep up with these parameters after quiet)

Press Ctrl + X to boot normally.

3. Hard Disk identification method for permanent startup

Enter the system as root, and edit/boot/grub2/grub. cfg in vi.

As shown in:

Find "linux17"

Press the End key to the End of the row.

Similarly, enter the "hpsa. hpsa_simple_mode = 1 hpsa. hpsa_allow_any = 1" parameter to keep up with these parameters after quiet, or else it cannot be started.

[: Wq] Save and exit

2.3 restart Test

1 reboot

 

 

As shown in:

Press e to enter the editing status.

Similarly, type the "hpsa. hpsa_simple_mode = 1 hpsa. hpsa_allow_any = 1" parameter.

Press Ctrl + X to boot normally.

 

Reference link:

Http://linux.it.net.cn/CentOS/CentosBug/2016/0514/21817.html

 

Http://www.linuxidc.com/Linux/2016-07/133089.htm