Install RedHatEnterpriseLinuxAS3.0 (using the ServeRaid7k Controller) on xSeries346-Linux Enterprise Application-Linux server application information. For more information, see. Secure service: Install Red Hat Enterprise Linux AS 346 on xSeries 3.0 (using the ServeRaid 7 k Controller)
1. Insert the RedHat disc into the disc drive and boot.
2. When the system prompts "boot,
Type linux dd and press Continue, prompt 'Do you have a driver disk', select 'yes', select fd0 as the driver disk source, insert the ServeRAID driver floppy disk, and check whether there are other driver disks, select 'no'
3. Check the disc and select 'skip '.
4. prompt the welcome information and press 'Next '.
5. If you are prompted to select language support, select 'Chinese (Simplified Chinese) 'and press 'Next '.
6. You are prompted to configure the keyboard. Select 'U. S. English 'and press 'Next' (Next)
7. Prompt to configure the mouse, select the common mouse type-2 (PS/2), and press 'Next' (Next)
8. On the 'disk Partition settings 'page, select 'manually partition with Disk Druid (Manually partitioned by Disk Druid)' and click Next ).
Note: If you are prompted that the 'partition table cannot be read, you must select 'yes' for initialization to create a new partition.
At least the following partitions must be created on the 'disk settings' interface:
A./boot partition: the Mount Point is '/boot', the size is up to 100 MB, and the partition type is 'ext3'
B. Root partition: Mount Point is '/', size is 2.0? 5 GB (fully installed as 3.8 GB), and the file system type is 'ext3 ';
C. Swap partition: the Mount Point is left blank and the size is at least 32 MB. It is better to double the system memory capacity but not exceed 2 GB. The partition type is 'SWAp '.
D. var partition: the Mount Point is '/var', the size is at least 3 GB, And the partition type is 'ext3'
...........
