Install RHEL6.2 (below) in VMware-RHEL system installation

Install RHEL6.2 (below) in VMware-RHEL system installation

Title: Installing RHEL6.2 (below) in VMware-RHEL system installation

Related: Installing RHEL6.2 (on) in VMware -- VMware Configuration

Reference: Full Process Diagram of VMware RedHat6.4 Installation

1. Open the installed virtual machine, because we did not set any RHEL installation source in the previous article, so it will be prompted:

2. Two Methods for changing the disc settings are marked on the image. both physical and virtual discs are supported.

1. Select ①:

2. Select ② and click Settings ...:

3. After setting the CD, restart the VM to enter the installation interface.

4. Go to the installation page and select the following options:

1. Install or upgrade an existing system: Install or update an existing system.

2. Install system with basic video driver: use the most basic graphics card driver to Install the Operating system (it does not affect the installation process, but the resolution is relatively low ).

3. Rescue installed system: Enter Rescue mode.

4. Boot from local drive: Boot from local disk.

5. Memory test: Memory test.

Here we can select the first one.

5. After loading. If you use a CD-ROM for installation, the following window will appear. This item is used to check whether the disc is physically damaged or injected with viruses.

6. After detection or skipping, the installation interface is displayed and click Next.

1 2 3 4 5 6 Next Page