Revert to a removable disk tutorial, just change mode =21 to mode =3 in the partition settings.
1. Open: "mpall_f1_9000_v329_0b" into the mass production interface:
2. Click "Setting" to enter the setting screen:
Select "New seting", "Advance Setting" point "OK", enter the setting screen:
3. IC_FW Tab Settings:
Language check "Simplified Chinese"
Main control selection: ps2251-60
FC1-FC2 oxff-Selection: 01
4. Flash Setting Tab settings:
Flash Selection: Auto Detect
Timing Selection: Default
Tick low-level formatting, other options default
5.Partition Setting (Partition Settings) tab settings:
Number of partitions: Select 1
Mode selection: 31 removable disks
Other places are default and cannot be changed arbitrarily.
6. Drive Info tab settings:
VID can be filled in according to the data detected by the chip wizard, such as:
Vid is 0951
PID is 1643
Name of Manufacturer: Kingston
Product model: DT 101 G2
Other settings default.
Need to detect the main control model, please use the production tool comes with GetInfo.exe
You need to enter a drive letter when you use it, and then click Read for master information.
If the amount of post-natal Chip wizard does not detect the main control model, I do not explain this, the Chip wizard is only a reference. (Please do not repeat on this issue) again, the need to detect the main control model, please use the Production tool GetInfo test.
7. Miscellaneous Setting (Other Settings) tab settings:
By default.
8. The above settings are complete, click "Save" to complete the setting
"The data had be saved" appears. Pop-up box, click Confirm
Click "Cancel" to exit the setup screen and return to the mass production interface (e.g.).
9. Click "Update" Update, will detect a USB flash drive: If not detected, please check the USB flash drive is plugged in, antivirus software is open, whether a little "Update" refresh.
Point "start" started mass production: in the production process, if there is a cue point to determine or OK, then follow the prompt to confirm or OK to continue to mass production, not in the production process of inserting or unplugging a U disk or power failure.
10. In progress ...
11. The Green Box interface will appear when the production is finished. Show Test finished
12. Secure the USB drive and reseat the USB drive as a disk:
To do Usb-cdrom, see Kingston u disk, Group ps2251-60 master, mass production CDROM tutorial
Kingston u disk, Group ps2251-60 master, mass production restore tutorial