Kingston U disk, group PS2251-60 master, production CDROM tutorial, ps2251-60cdrom

Kingston U disk, group PS2251-60 master, production CDROM tutorial, ps2251-60cdrom

Pre-production preparation:

1. Plug in the USB flash drive (after the chassis for the desktop)

2. Anti-Virus Software (especially 360) should not be installed on a computer)

3. ISO Image File

4. Download MPALL v3.2920. B .zip

 

Please read the tutorial with patience:

1. Open "mpall_f00009000_v329_0b" to go to the mass production page:

 

2. Click "Setting" To Go To The Setting screen:
Select "New Seting" and "Advance Setting" click "OK" to go to the Setting screen:

 

 

3. IC_FW tab settings:
Select "simplified Chinese"
Master Selection: PS2251-60
FC1-FC2 OXFF-selection: 01

 

4. Set the Flash Setting tab:
Flash Selection: Automatic Detection
Timing Selection: Default
Select low-level formatting. Other options are default.

 

5. Partition Setting tab settings:
Number of partitions: select 2
Mode Selection: 21 (A USB-CDROM + a removable storage partition, note that do not mass production as a fixed disk)
Select the path of the ISO image file in the CD image: You need to manually select the file, the file must be in ISO format, find the ISO image file you want, open it and select the ISO image you want.
It cannot be changed unless otherwise specified.

 

 

6. Set the Drive Info tab:
You can enter the VID based on the data detected by the chip genie, for example:

 
VID is 0951
PID is 1643
Manufacturer name: Kingston
Product Model: DT 101 G2
Other settings default.

Use the getinfo.exe tool to check the main control type number.

You need to enter the drive letter when using it, and then click Read to Read the master information.

If the master control model cannot be detected by the chip genie after the birth, I will not explain this. The chip genie is just a reference. (Please do not repeat it on this issue)
Again, the main control model needs to be checked. Please use the GetInfo detection tool.

 

7. Other Setting (Other settings) tab settings:
By default.

 

8. The preceding settings are complete. Click "save" to complete the settings.

The "The data had be saved." dialog box appears. Click OK.

Click "cancel" to exit the setting screen and return to the mass production interface (for example)

 

9. Click "Update" to Update the USB flash drive. The USB flash drive will be detected. If not, check whether the USB flash drive is plugged in, whether the anti-virus software is turned on, and whether the software is updated.

Click "Start" to Start mass production: during the mass production process, if you are prompted to click OK or OK, click OK or follow the prompts to continue the mass production. During the mass production process, you cannot plug or remove USB flash drives or power outages.

 

10. in progress ......

 

11. After mass production is completed, a green box interface will appear. Show Test Finished

 

12. In this case, the mass production has been completed, for example, a CDROM installation disk and a disk:

 

 

To restore a disk, you can refer to the Kingston U disk, group PS2251-60 master, mass production recovery tutorial