Lenovo notebook to increase NGFF solid state hard disk installation of specific tutorials

A long time, the money in the running speed on a lot of slow, how to upgrade the book? Increased memory and other hardware ways to improve the performance of the notebook is far from the use of solid State drive to enhance the obvious, so today I share with you to the ThinkPad E431 notebook to increase the solid-state drive method and experience.

Solid State Drive to enhance the performance of the principle: solid-state hard disk can be understood as the same as the U disk chip firmware, do not want the traditional hard disk that need to have a rotating disc, naturally there is no speed of the problem, the largest reading and writing speed in 500m/seconds, so faster than the traditional hard drive Natural for the system to improve the operation is also very obvious!

1, in addition to the solid-state drive before the Association customer service, ask if your computer has a solid-state hard disk interface, if not, need customer service to help you provide other solutions (some can use the optical drive interface to install solid-state drives, this is not the problem solved by this article, Because the problem involving solid-state hard disk racks and related interfaces is not easily solved by individuals, it is recommended to the After-sale station to deal with.

This experience is the same as the E431 notebook has solid-state hard disk interface installation method. Let's take a look at what needs to be prepared.

2, I passed to the Lenovo engineer to send a notebook serial number after the machine to support the NGFF interface of solid-state drives, this is very important, different interfaces can not be general, so be sure to consult Lenovo engineers, according to the engineers provide technical information to buy, otherwise, you know.

3, the notebook shutdown after the ground is placed on the table, with a screwdriver in turn remove the solid State Drive area of the rear cover screws.

4, with a screwdriver to remove the corresponding cover plate screws, and as shown in the following method to lift the cover plate removed, remember to use a screwdriver and other hard goods pry, this will damage the computer parts.

5, the solid state hard drive in the figure shown in the position inserted.

6, in the solid state hard drive tail screws fixed, the general association of solid-state drives have a screw, if not, please to the aftermarket station to a can, do not use other substitutes!

7, put back the cover plate, and first with the hand gently press down the cover plate to make the cover plate flat and then tighten the screws in turn.

8. At this point, the solid state hard drive has been installed, but the performance has not been improved, because we have not yet used it.

We need to enter the system, the first to just install the solid-state hard disk partition, of course, if it is the direct use of 64G, but my 128G, but also can be divided into a district, so to the Win7 system disk left behind a 60G system disk, the rest as a tool tray to use. Note At this point: WinXP does not support solid-state drives, please use Win7 or win8 systems. Then use the Ghost tool to ghost the system disk data from the original hard disk to the system disk just partitioned. Of course, also need to cancel the original letter in DOS activation state, the starting mode to make appropriate changes and so on.