MPLAB X IDE v3.05 cannot use ICD3 download program

1, concluded: ICD3 emulator bad

2. Test environment

1) IDE: MPLAB X IDE v3.05

2) compiler tool chain: XC16 (v1.21)

3) MCU: pic24f08ka101

3. Test method

1) confirm the line sequence of the ICD3

2) confirm the emulator pin on the schematic diagram of the single-chip microcomputer

3) Wiring Method

The connector which is terminated by the simulator is introduced by the pin and directly welded to the simulation port of the target plate.

4) Power on the target board

5) emulation using the IDE

Get the following error message

6) Find a Kit3.5 two days later and prove that the line sequence is consistent with the original ICD3:

7) Configure the Hardware tool on the IDE for KIT3, point application

8) Simulate and see the debug cursor.

9) At this point, the basic confirmation is ICD3 bad. (or, still not understand the use of ...) ）

MPLAB X IDE v3.05 cannot use ICD3 download program