PCB Layout Tips

Open the schematic and the corresponding PCB, click Pads Layout in the toolbar to connect the schematic and PCB.

Right-Select the original in the schematic to select a module, and then right-click on the PCB to select a module to put together.

When moving, rotate the originals by pressing the TAB key, Ctrl+e move the originals, and press Ctrl+r in situ. Select the original right-click feature to place the originals on the bottom, ctrl+f can place the originals on different layers when moving the originals.

The original position is moved by selecting right-click to move the origin, double-clicking to change the coordinates of the original. After the coordinates are set up, you can lock the originals in the PCB. Double-click the original dialog box to select Glue.

Moving the original when the grid G is set to a smaller point is moved by the grid size.

Set the original to take the line short and straight line as the target.

Rule settings

The popup dialog box is set

Reference settings

PCB Layout Tips