Pcduino brush system via SD card

1. log on to the pcduino official website and download the corresponding files.

Download the first kernel and the later ubuntu.

2. Insert the SD card to your computer and run the following software:

The drive letter is the drive letter of your SD card. Select the card for mass production, select the one in the image file, and click "burn". After the installation is complete, exit. Unplug the SD card, insert it to your computer, and copy the unzipped folder (pcduino_ubuntu_20131126.img update. Sh.

3. Insert the copied SD card to the board and connect it to power-in.

4. the LED light flashed in the middle and went off. Disconnect the power supply and remove the SD card.

5. Connect the power cord and find that one light is always on and the other is flashing. This step is complete.

6. Plug in the SD card. Do not unplug the power cord. After the SD card is inserted, the light that was previously in the flash is flashing. In fact, this flash process is to upload the copied items to the Board, which takes about 10 minutes.

7. When the transfer is complete, the light will flash slowly and the two lights will flash simultaneously, indicating that the update is complete.

8. Unplug the power supply and unplug the card. Do not plug in the card later.

 

Pcduino brush system via SD card