Photoshop deducts hair in a complex background

Step1

As can be seen from the figure below, model is not filmed in a clean background, but is filmed on a bed shop, and there is no special lighting.

Step2

After you know this image, then cut to "color version", the duplicate of a hair and background of a larger color version, after the restoration, then press Ctrl+i to change negative effect.

Step3

Next, perform the function table/image/adjustment/brightness/contrast options, first the lower right corner of the use of the old version of the selection, and then enhance the contrast between the images.

Step4

Select the Toolbox/Highlight tool and set the range to "light" to highlight the body edge of the model until it becomes white.

Step5

First the edges are treated as follows.

Step6

Then use the Lasso tool to select the middle block and fill it with white.

Step7

Then choose the Deepen tool, the range is shaded, then start to darken the edges.

Step8

I can finally start to repair hair, in the anti-white state, can clearly see a trace of hair, because the white has the expansion effect, the black will have the contraction effect, by this characteristic, may clearly see the hair silk part, when the repair almost then presses the ctrl+i again to turn back, from the next will see several places did not fix, This shows that white will swell, so as long as in black, a little white will soon be identified, back-view hair silk is also, in the black hair although also see, but there is no white to strong, mainly because when the white background black hair, some of the more subtle hair will be white bottom expansion to slightly off, Therefore the black bottom white hair is the better distinguishing environment.

Step9

All right. Next, open the color level, select the bottom left of the dropper, to the black bottom suction, make sure this black is black.

Step10

Hold down the CTRL key on the shading version of the thumbnail, and then click the left mouse button to cut the layers panel down to Ctrl+j, add a new layer and fill in the red.

Step11

At this point you can know that there is no clean or white edge, such as the white side can refer to Photoshop teaching-decisive battle 60 seconds-eliminate the white edge of hair silk to go behind.

Step12

Casually pull a landscape map to test see, ha ~ Hair silk is moving and no white edge.

In fact, the former is directly white under the black hair, and is used to set the color of the black and white way to filter out the parts, in fact, some of the finer hairs are sometimes sacrificed, but today in the anti-white and using the deepening and highlighting tool, you can more accurately filter out the parts to and without, and the effect is quite good , you do not have time to try, but also without the benefit of the path tool, directly add to add to the deal!

Category:

• PS Pull Map Tutorial