Photoshop to fill graduation photos missing portrait

University four years of Time Flash, in the proximity of graduation to feel the affection between alumni precious. In the most memorable graduation photos I was in a humble corner, in addition to one of my head, the facial features are not seen. Is Yushu the way I was buried before? No, no one's going to steal my thunder!

After a PS (Photoshop processing), I finally stood in the most handsome attitude of the prominent position (Figure 1)!

Like the above situation in the graduation photo often, but this in the later processing can modify the deficiencies. Just master some of the tips in Photoshop and you can do it easily.

　　Pre-Preparation

According to the graduation photo, first determine the position you want to stand, and then use a digital camera to take a single photo of you, pay attention to your position as far as possible to put the posture required to maintain the same posture with everyone.

Suggestion: In the shooting time background best choice white interlining, in order to facilitate in the next step will pull out the character.

actual Combat

1. Import the picture to your computer and open it with Photoshop. If the background is simple, use the Magic Wand tool to select the background, and then reverse the selection, in a slightly more complex section, you can select the character part using the Lasso tool or the line selector in the toolbox, and then press the "CTRL + C" key on your keyboard to copy the selected characters.

　　tip: When choosing, the edge of the characters as far as possible do not leave white, or the characters will not appear natural. 2. Open graduation photos, press the "CTRL + V" key combination of the selected characters, press the keyboard "ctrl+t" key combination, with the mouse hold the upper right corner of the adjustment handle. Adjust the size of the character (Figure 2) and put him in the right place. When scaling, hold down the SHIFT key on the keyboard and zoom proportionally.

3. Press the "Ctrl+u" key combination on the keyboard, in the "Hue/saturation" of the control Panel to adjust the hue, saturation, brightness of the slider, to adjust the pasted in the color of the characters, so that it as far as possible with the image of the characters in the same color.

4. After determining the position of the characters, open the Layer Control Panel, on the layers panel we see the copy in the figure layer is "layer 1", the transparency above, set it to 50% or so (Figure 3). We can see the characters that are copied in the graduation photo become transparent.

5. Select the line Selection tool in the toolbox. With the transparency effect, it's easy to select the previously shaded section and press the DELETE key on the keyboard to delete the selected part, and then adjust the opacity to 100%.

Finally, you don't want to keep the image of your previous location, use the selection tool to select it, then fill it with a background color, or repair it with a rubber stamp tool.

At this point, the whole picture of the repair is completed. If you think the picture is too stiff and lifeless. You can add some small decorations to liven up the atmosphere (Figure 4). The above method is only for reference, creativity to play it yourself.