Photoshop+camera Raw 6.1-tone fashion Black-and

Effect comparison

The following points should be noted when making reference to the image style when adjusting the ordinary shed to shoot portraits:

1. Turn black and white when you need to pay attention to the adjustment of the dark layer, so you should reduce the appropriate black.

2. The use of lens correction function of the four corners, the degree of compression should be based on the specific circumstances of the photo (composition form, figure proportion, etc.).

3. Adjust the color level is to enhance the picture of the contrast between the light and shade, so that the image more three-dimensional.

4. The use of color balance can be a good black and white photos attached to color, can also be for the image of the dark, high light and the middle of the adjustment respectively.

5. The stamp tool is simple to use and can be modified by coloring and copying. And it's hard to master the stamp tool. modifier characters, take color is very critical, according to the direction of the people's skin, through the control of the seal of transparency, hardness, flow, size, etc. to modify, to practice to make good results.

6. Use the Liquefaction tool, pay attention to the characters and the structure of the skeleton. Lens blur function can adjust a lot of parameters, such as aperture-shape, so as to control the fuzzy shape, make the effect more realistic

Detailed steps:

Adjust this kind of photos, we should mainly use Cameraraw software to adjust the photo to black and white photos, make dark angle, then use the PS filter lens blur to do the blur, and then in the mask to erase the need to keep the site.

The first step: in the camera raw software in the initial image

With Cameraraw software, the image can be adjusted preliminarily and the tone of the image is determined. In this step of adjustment, as far as possible to preserve the image of black, white, gray level.

Cameraraw in CS5 has been integrated, other versions have no Cameraraw students can go here to download: http://fly.86ps.com/thread-5797-1-1.html

Adjust in the "basic" panel. Reduce the "black" is to increase the level of the dark, to increase the "transparency" in order to improve the contrast of the picture High contrast, so as to improve the sharpness of the picture, reduce the "saturation" to make color pictures into grayscale images.

Enter the "Lens correction" panel to make the image dark around the effect. Adjust the number of "lens halo" and "trimmed Halo shadow" to adjust the location of the center point.

Step two: Use Photoshop to adjust the contrast of the image

For a black-and-white photograph, the transition between light and shade and black, white and grey is very important. There are a variety of ways to adjust image contrast, where we use the level tool to adjust the contrast and use the color Balance tool to adjust the color of the photo.

The adjusted image is a bit gray, so use the "level" tool to adjust the contrast of the picture, so that the contrast between the light and shade of the photo more strongly. Note that the high light and shadow parts can only be fine-tuned, not tuned, otherwise the high light and shadow parts will lose levels.

Use "Color balance"-"midtones" to adjust the color to make the picture slightly bluish-green.