PS for the Ruins portrait Add a touch of dim beauty

Ningguo Road Ruins, Shanghai is the recent comparison of a fire outside the ground. However, with more and more pieces of debris, we found that most of the film is Decadent wind, and later on is mostly low saturation or even black and white, do the old effect. It is tempting to ask: The ruins must be filmed so decadent despair? Today's tutorial to teach ourselves to create a simple props, and then supplemented by the corresponding later, for the ruins portrait Tim a touch of hazy beauty, let hazy dream wind of the ruins portrait walk up ~

Shredded Red Author: Xiao 11 Wolf

The first is the building of props. Said is a prop, in fact, just a plastic wrap can be seen in advance to prepare a fresh film, painted on the above color, wrapped in front of the camera as a foreground, so that the original film appears multicolored light.

This time I choose to paint on the preservation of the film red and yellow to create a hazy feeling, because the model's clothing is red, so when you pay attention to increase the proportion of yellow, reduce the proportion of red, and then in the middle of the plastic film to dig a small hole for focus. The actual situation as shown in the picture.

Next is the later steps, first of all raw format to do simple processing, the original piece is some dark, mainly to do the lighting processing, and enhance sharpness, for the follow-up to create a hazy feeling to prepare.

Then open the picture in PS, mentioned above in order to facilitate the focus, we have left a small hole in the middle of the film, but this will result in the middle of the original image is more sharp, and in the screen left small hole traces of the consequences, so the first thing to do is to adjust the sharpness of the whole Here we use the comparison method of reference, is to improve the sharpness of the periphery of the hole to achieve the full picture consistent sharpness effect. The steps are: first copy a layer, then add sharpness, and then add a mask to wipe out the center area.

Similarly, due to the center of the small hole, the center point of the brightness and edge of the different, so you can add a brightness mask, parameters such as figure:

After the effect of the figure, small holes caused by the impact of the basic elimination.

Then the layer, adjust the light, the original image has a linear ray of the prototype, we have to do is to make this contrast more prominent. can be added brightness mask, the overall light, and then use a mask to wipe out the dark, in order to the authenticity of light, to adjust the transparency of the eraser. Then the whole light up, come out after the effect as shown.

For the overall dream effect, we can use the aperture blur to soften the picture, into the filter-blur-aperture blur.

Adjust the layer transparency to achieve a virtual and sharp balance.

Then start the palette. As a result of its own color film plus color, so there is no need for more than a few steps, the main is to increase the saturation, increase the brightness and saturation of red, adjust the red-green curve makes red not too greasy. The main steps are as follows:

The theme of this group is red, so we use the pink brush in the appropriate place to apply some light red, to increase the effect. Out of the effect as shown.

Then add the text and logo is done! The final figure is as follows!

Note : More wonderful tutorials Please pay attention to the triple Photoshop tutorial section, triple PS group: 339853166 welcome you to join

Category:

• PS Image Processing