This article mainly introduces how to set up the TP-LINK in different broadband modes, and gives the specific operation diagram, I believe it will help you after reading.
TP-LINK ROUTER settings 1, ADSL: ADSL access is divided into adsl modem and adsl router, if it is adsl router, you need to change the Internet mode to RFC 1483 bridge, and then connect to the TP-LINK ROUTER. Then login TP-LINK Router WEB management interface, through the "Setup Wizard" select ADSL virtual courtesy dialing method, the service provider provided by the "Internet account" and "Internet password" fill in the corresponding location, click Next.
TP-LINK router settings 2, VDSL: its access settings and ADSL are the same. But in some places, you will encounter can be on QQ, but can not open the page, then you need to log on to the TP-LINK router, network parameters in the WAN port settings, MTU value to small, the default value is 1492.
TP-LINK router settings 3, FTTB + LAN Dynamic IP + WEB Authentication: Login TP-LINK Router WEB management interface, through the "Setup Wizard" select "Ethernet bandwidth, automatically from the network service provider (for example: china Telecom) Get IP address (Dynamic IP address) ". After the configuration is complete, go to the running status to see if the WAN port has obtained the IP address. Then, enter any URL in the IE Address Bar, the authentication dialog box is displayed. Enter the user name and password provided by the network service provider.
TP-LINK router settings 4, FTTB + LAN static IP + WEB Authentication: Login TP-LINK Router WEB management interface, through the "Setup Wizard" select "Ethernet broadband, network service providers (such as: China Telecom) provide a fixed IP address (static IP address). After the configuration is complete, enter any URL in the IE address bar. The authentication dialog box is displayed, enter the username and password provided by the network service provider.
TP-LINK router settings 5, wired broadband Internet access: Login TP-LINK Router WEB management interface, through the "Setup Wizard" select "Ethernet broadband, automatically from the network service provider (for example: China Telecom) obtain the IP address (Dynamic IP address). After the configuration is complete, restart the cable modem.