Switch VLAN division configuration (PT simulator)

I have just been familiar with the basic configurations of the VLAN division experiment of the switch VLAN division configuration (PT simulator). I am not familiar with this knowledge for too long. Please forgive me for any errors, this configuration is for you to learn about the Cisco simulator configuration case. Www.2cto.com Switch> enSwitch> enable Switch # confSwitch # configure Switch # configure terminal Enter configuration commands, one per line. end with CNTL/Z. switch (config) # in vSwitch (config) # in vlan 1 Switch (config-if) # ip add 192.168.1.4 255.255.255.0Switch (config-if) # no shutSwitch (config-if) # no shutdown % LINK-5-CHANGED: Interface Vlan1, changed state to up % LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to upSwitch (config-if) # exitSwitch (config) # vSwitch (config) # vlan 100 Switch (config-vlan) # exitSwitch (config) # vlSwitch (config) # vlan 200 Switch (config-vlan) # exitSwitch (config) # in rSwitch (config) # in range f0/1-8Switch (config-if-range) # swSwitch (config-if-range) # switchport mSwitch (config-if-range) # switchport mode aSwitch (config-if-range) # switchport mode access Switch (config-if-range) # swSwitch (config-if-range) # switchport aSwitch (config-if-range) # switchport access vSwitch (config-if-range) # switchport access vlan 100 Switch (config-if-range) # exitSwitch (config) # in rSwitch (config) # in range f0/9-16Switch (config-if-range) # swSwitch (config-if-range) # switchport mSwitch (config-if-range) # switchport mode aSwitch (config-if-range) # switchport mode access Switch (config-if-range) # swSwitch (config-if-range) # switchport aSwitch (config-if-range) # switchport access vSwitch (config-if-range) # switchport access vlan 200% LINEPROTO-5-UPDOWN: Line protocol on Interface Vlan1, changed state to downSwitch (config-if-range) # exit