Synology NAS Storage Method for installing DSM _ Server Other

Synology NAS Storage Installation DSM

One: The premise of this step is that you can already find NAS devices in your network by using the software (Assistant). Next we'll install the DSM system.

Second: Start your assistant software, click Search. The first step shown in Figure 1 below:

Figure 1

Three: The selected state information is "DSM not installed" NAS devices, as in the second step of Figure 1, where the installation is displayed online. As in Figure 2, step three.

Figure 2

IV: After clicking on the installation, it appears as shown in Figure 3 below. Click here to browse for your DSM system file, a file with a suffix of ". Pat", where you must match your system model with your NAS device model, or you may not have a successful system installation.

Figure 3

Five: After clicking out as shown in Figure 4 below, find the matching DSM files, select the matching DSM files, click Open, and enter the following operation.

Figure 4

Six: Then go to Figure 5 below: If you find that your DSM is wrong, click on the seventh step to cancel the installation and return to the beginning of the new installation.

Figure 5

Seven: About a few minutes (this time with your network and equipment hardware performance of the number of hard disk related) and so on after the completion of the confirmation, click to complete the installation of the DSM.

FAQ

1: The installation has been waiting for a long time, there is no hint of installation success, this you first need to check your device model to match your selected DSM version number, this is important to match, if you use a notebook, you need to access wired network, the use of wireless may also cause this problem. Finally a successful step to forget the screen, but if successful there is nothing to do the confirmation, close.