System Disk Burning Disc tutorial

Now the internet has a lot of computer enthusiasts to make the operating system or backup like the system, for the vast number of users have their own loyalty to the system, but for some collectors of system enthusiasts often ask a question "How to burn the system disk?" For the convenience of these enthusiasts, make a special tutorial for using Nero 9.0 burn to everyone.

　　First we have to prepare 2 things:
First: Nero 9.0 Green Mobile version (supports Chinese long file name burning, can burn many types of disc).

Second: You can go to our xp74.com download the latest system disk, here we demonstrate the computer company special edition of the installed version.

Learning operations

Nero9.0 because the green version of the direct can be used without installation. If you are not available, please click Green Tool Greening. Let's start with burning the data CD, familiar with the function of Nero9 and the meaning of each option. The new version of the Nero9 start interface compared with the past has a relatively large change, reflecting the software users of the considerate and care.

The first step: Open the window of the Nero9.0 to appear. (Figure 1)

(Figure 1)

Step Two: Select Files-When the new task is opened, the following interface appears. (Figure 2)

(Figure 2)

The third step: Open the selection of xp74.com download good system, here we demonstrate the selection of the computer company special Edition installed enhanced version. (Figure 3)

(Figure 3)

Fourth Step: Open the selection will pop the selection burner (CD-RW or DVD-RW) selected drive, OK. (I'm here because it's a virtual test, so unlike yours, if you already have a burner, it will appear (CD-RW or DVD-RW). Choose him to be sure. (Figure 4)

(Figure 4)

Fifth step: If you want to append the data next time, please tick "write", if you fill the entire disc or do not want to write the data again, check "end disc" to close the entire disc. "Determine maximum speed" is to test the system before burning can keep up with the burning speed, such as the speed is not enough to reduce the burning speed, to some extent, to avoid the occurrence of the burn failure. The role of "impersonation" is to simulate the entire process of burning before the actual burn "write speed" can be set to write speed, such as time should be used to try to use low speed to burn, not only the success rate is high and the risk of burning less. The "CD-ROM" in the Write method is actually the DAO mode. Burn copies to set the number of discs burned. There is usually an option in the place next to the "Burn number", which is mainly for the option of some techniques to prevent death. If the burner can support these features, the corresponding feature options will be turned on and need to be played on the Cai in this position to enable the corresponding engraved technology to take effect. (Figure 5)

(Figure 5)

The sixth step: the above all set up, we can press the "Burn" button to start burning. OK, just wait a little while ... This is the complete process of an Nero 9.0 burn system. (Fig. 6 Figure 7)

(Figure 6)

(Figure 7)

This is where the burn is done.

Note : More wonderful tutorials Please pay attention to the triple computer Tutorials Section