Tp-link Enterprise Router VPN server side how to set up

Tp-link Enterprise Router VPN server-side setting method

After logging in to the router, click Object Management, we set up a set of IP address pool for the VPN dial-up end to use after the client dials successfully.

Note: Lan_pool is the address pool for internal DHCP, PPTP2 is the address pool used for VPN.

Then click on the VPN entry on the left, select the PPTP protocol to enter the PPTP server settings interface, the specific settings can be referred to as shown in the figure:

The local address needs to be an unused IP address within the local LAN.

Binding domain is a fixed IP or dynamic domain name of the binding port, I am here is 4 lines at the same time dial-up Internet, so I chose together.

Address Pool Select PPTP2.

The final results are as follows:

Once the End-to-end VPN dial-up is successful, you can find connected dialing information in the PPTP server tunnel information, indicating that the connection was successful.