Tp-link Home no wiring by installation and setting method

Maybe a lot of people do not understand the family without wiring by the setting is how to operate, there is no relationship, read this article you must have a lot of harvest, I hope this article can teach you more things.

Tp-link home without wiring by setting this brand is also quite well-known in the country, cost-effective, cheap and enough, this line from the cost of only 200 yuan, is also a 11N protocol wireless router among the cheapest one.

Tp-link home without wiring by installation

Let's first understand the effect of each led without a line

PWR is the Power LED

SYS is the system status led, and its flashing indicates that the device is working properly;

WLAN is the wireless status indicator, flashing indicates the wireless function startup state, which indicates that the wireless function is not started;

1~4 is the LAN status LED, flashing indicates that the LAN port of the host network connection is normal;

WAN is a wide-area network status indicator, constants and flashes all indicate working properly, flashing indicates data exchange;

The lock lamp is the safe connection led, the green flashing indicates that the safe connection is normal, the red indicates the failure; the router's connection is simpler, first the adapter is plugged into the mains, the other end is plugged into the rear of the router, it does not have a switch and the power begins to work. Turn on the laptop wireless network card switch, and in a moment you will be able to find the wireless signal from the router in the management of Windows wireless networks.

Adslmodem output of the network cable, plugged into the router's WAN, it's done! It's all so simple!

Tp-link Home no wiring by setting

When the wireless router is connected to the power, it is in a working state, turn on the laptop wireless switch, so that the wireless card is in normal working status See Windows Control Panel-Network and Sharing center-connected to the network window, you can automatically find the name of the router's SSID.

Note here that the wireless router is turned on with wireless and DHCP enabled by default. If you are using a LAN port for the router setup, you need to set the IP address of the computer network card and the router in the same paragraph can normally access the router yo!

Double-click the SSID name and wait a moment for the wireless card to connect to the router. After the correct connection to the route, we only need to click IE Browser, in the address bar input: 192.168.1.1 Username: admin Password: admin can enter the Tplink router inside the Settings page. User name password sticker on the bottom of the router, we pay attention to look at, in fact, all brand routers are designed this way, but the initial IP address and user name may be different; When everything is right, it comes into this.

Tp-link Home No Line by setting click Next after the choice of ADSL virtual dial-up (PPPOE) after entering your home Internet account, password next to the general family Broadband network connection, the vast majority of ADSL dial-up mode, starting from here will be an example of ADSL way to introduce the setting way, After we enter the Router Settings screen, click on the left side of the "Setup Wizard", follow the prompts click "Next" to set the connection mode.

ADSL for Ppoe Way, select it, Next, enter your ADSL account name and password (note case sensitive), OK, tp-link home no Line by setting next, into the simple wireless settings, wireless "Open", SSID name ( This name is the name of the wireless signal you searched for the route, the rest defaults, Next, ok! complete! If you do not need a home without wiring by setting other related functions, at this time see the wireless router "System tool" click "Restart the Router", a little wait for the router restart completed, set the correct words, You can dial the Internet properly.